Nature’s Prints Suite – Tag Card

I am so pleased to once again be able to participate in Kylie’s International Winners Blog Hop. Thank you everyone so much for voting for my card. This is the card I entered in the Blog Hop that everyone voted for. To see how it was created here are the cutting and instructions for it.

My card that I’m entering in the Winner’s Blog Hop is made with the New 2022-2023 Suite called the Sun Print Suite. This suite features beautiful Designer Series Paper and the Nature’s Print Bundle. I am so excited to use the New In Colors as well.

Here are the cutting and instructions to make my card:

1. Card base is Starry Sky card stock cut at 8 1/2″ x 5 1/2″, scored and folded at 4 1/4″.
2. Basic White layer is 4″ x 5 1/4″ which has been embossed with the New Fern 3D embossing folder. Attach the embossed layer to card base with liquid glue.
3. Cut a strip of the Starry Sky card stock at 1 3/8″ x 5 1/4″.
4. Cut a piece of the Sun Print Designer Series Paper 1 1/4″ x 5 1/4″ and attach it to the Starry Sky Card stock with liquid adhesive, then attach this layer to the card with liquid glue.
5. Die cut a Basic White tag using the Tailored Tag Dies and stamp an image from the Nature’s Print stamp set in Starry Sky ink.
6. On the back side of the Layering Designer Vellum that is 2″ x 4 1/2″ lightly brush with Night of Navy ink.
7. Die cut 2 Circles using the Layering Circle dies.
8. Die cut a smaller circle in Starry Sky card stock and heat emboss a sentiment in White Embossing Powder.
9. Cut a piece of the Metallic Mesh Ribbon about 4″ and then cut it in half the long ways to make a narrower strip.
10. Thread the ribbon through the hole in the tag.
11. Attach the tag with dimensionals on a slight angle to the card.
12. Slip the 2 circles under the tag and attach them with a couple of Glue Dots.
13. Place the Sentiment on the tag with some dimensionals.
14. Add 3 Basic Rhinestones to the card for some bling.